Sirius SLT950 EM Bedienungsanleitung Mit Montageanweisungen Seite 18

MAINTENANCE
An accurate maintenance guarantees good
functioning and long-lasting performance.
A special care must be paid with grease fil-
ters: to remove the grease filter please follow
the instructions given in the 'USES' section ,
according to the model chosen.
Remove the grease filter by pulling its handle.
To reinsert the grease filter after the clea-
ning, just perform the opposite operation.
Attention: after refastening the stainless ste-
el panel make sure that it is properly fixed.
To clean the appliance itself tepid water
and neutral detergents are recommended,
while abrasive products must be avoided.
For steel appliances specialized detergents
are recommended (please follow the instruc-
tions mentioned on the product itself to ob-
tain the desired results).
To replace the lamp, (SLT950 EM- SLT951
EM , SLT950.1, SLT953 ) remove the lamp
(Fig. 9) and replace it with a lamp of the same
kind.
To replace the fluorescent lamps (SLT952
and SLT952EM) you need to disconnect the
appliance from the electrical network, then
open the panel following the instructions gi-
ven in the 'USES' section.
Remove the perimeter screws shown in fig.
14; pull the fluorescent lamps support out
(fig.15), and replace the old lamp with a new
one of the same kind.
Refit the panel and the screws previously re-
moved.
To replace the fluorescent lamps ballast plea-
se follow the steps described above.
If the panels of the hood SLT952 are out of
line and not perfectly flat, it is possible to re-
gulate the screws fixing the panel, in order to
align them and make them flat again.
After you have opened the panels, according
to the preceding instructions, unscrew the
screw you can see on picture 18 and lift up
or down the panel in order to align it with the
other and make them perfectly flat.
Tighten the screw you had loosen and close
the panel.
Substitution of the LED bar:
Using an appropriate tool, remove the LED
bar from its seat (refer to Fig. 19), disconnect
it electronically using the appropriate con-
nector then substitute it with a LED bar with
same characteristics.
18