Mounting The Blades; Removing The Blades; Mounting The Loop Handle - Stihl FSA 45 Gebrauchsanleitung

English
► Thread the mowing line through the left opening from
above until the end of the line reaches the symbol.
► Hold the short end of the mowing line firmly.
► Pull the long end of the mowing line until it is tight against
the mowing head.
► Cut the mowing lines so that they extend as far as the line
limiting blade.
7.2.2 Removing Mowing Lines
► Switch off the trimmer and remove the activation key.
► Push the short end of the mowing line upwards out of the
mowing head.
► Pull the short end of the mowing line upwards out of the
mowing head.
► Pull the mowing line out of the mowing head.
7.2.3

Mounting the Blades

► Switch off the trimmer and remove the activation key.
► Place blades in a container filled with water for 12 to 24
hours before using.
This makes the blades supple.
42
2
1
1
► Position the blade (1) on the mowing head so that the
bushing (2) locates in the large bore in the blade (1).
► Pull the blade (1) outwards until the bushing (2) engages
the small bore in the blade (1).
7.2.4

Removing the Blades

► Switch off the trimmer and remove the activation key.
30°
2
1
► Push the blade (1) inwards until the bushing (2) is
released from the small bore in the blade (1).
► Remove the blade (1) upwards.
7.3

Mounting the Loop Handle

► Switch off the trimmer and remove the activation key.
7 Assembling the Trimmer
2
0458-718-9821-B