Trailering - TOHATSU MFS 6BZ Benutzerhandbuch

56
REMOVING AND CARRYING THE OUTBOARD MOTOR
ENON00021-1
Note
If the outboard motor must be laid
down be sure drain the fuel, then the
port side faces down as shown in the
following drawing.
Elevate power unit 2 inches to 4
inches if traveling to avoid oil spillage.
8
ENOM00072-A

3. Trailering

ENOW00072-0
Trailering in the tilted position may cause
damage to the outboard motor, boat, etc.
ENOW00073-A
Be sure to disconnect fuel connector except
when operating engine.
ENOF01416-1
ENOF01415-0
CAUTION
WARNING
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00068-0
WARNING
Close air vent screw of fuel tank and fuel
cock before carrying or storing outboard
motor and fuel tank, or fuel may leak,
potentially catching fire.
ENOW00071-0
CAUTION
The tilt support device supplied on your out-
board motor is not intended for towing. It is
intended to support the outboard motor
while the boat is docked, beached, etc.
When transporting a boat on a trailer
with the outboard motor still attached,
disconnect the fuel line from the out-
board motor beforehand and keep the
outboard motor in the normal running
position or on a transom saver bar.
Tiller handle type
To prevent the outboard motor from
moving when it is attached on a boat
during transport on a trailer, properly
tig hten the ste ering fric tion le v er
(page 58).
ENOF00075-1