Before Fi Rst Use; Assembling The Appliance; Cutting Blades - Silvercrest KM 250 A1 Bedienungsanleitung

WARNING! RISK OF INJURY!
To avoid personal injury and damage to the appliance, never insert or
►
place your hands or any foreign objects into the feed tube.
Do not change accessories unless the drive is stationary and the mixer is
►
unplugged from the power supply! The appliance will run on for a short
time after being switched off !
Never leave the appliance unattended!
►
Before changing accessories or additional parts that are in motion during
►
operation, the appliance must be switched off and disconnected from
mains power.
Before fi rst use
■ Remove all packaging materials from the appli-
ance.
■ Clean the appliance as described in the section
"Cleaning and care".
■ Ensure that all parts are completely dry before
operating the appliance.

Assembling the appliance

NOTE
The appliance will not start until the bowl 5
►
and the lid 3 are correctly attached.
1) Place the motor unit 7 on a fl at surface so
that the sucker feet can attach fi rmly and the
appliance stands fi rmly in place.
2) Place the bowl 5 onto the motor unit 7
so that the arrow
towards the open lock symbol
motor unit 7. Then turn the bowl 5 until the
arrow points to the closed lock symbol
and the bowl 5 clicks into place.
If you want to work with the cutting blades 4,
assemble the appliance as described in the section

"Cutting blades".

If you want to work with the food processing at-
tachments, assemble the appliance as described
in the section "Food processing attachments".
KM 250 A1
on the bowl 5 points
on the
Cutting blades
1) Place the cutting blades 4 onto the drive
shaft 6. The fl attened side of the drive shaft 6
must correctly fi t into the take up of the cutting
blades 4. Otherwise the cutting blades 4
cannot be properly attached.
2) Place the lid 3 onto the bowl 5 so that the
on the lid 3 coincides with the
arrow
arrow and the opened lock symbol
on the bowl 5.
3) Turn the lid 3 until the arrow
points to the arrow
on the bowl 5.
symbol
4) Place the pusher 1 into the feed tube 2.
5) Insert the plug into a mains power socket.
on the lid 3
and the closed lock
5
GB