Before Fi Rst Use; Assembling The Appliance; Cutting Blades - Silvercrest KM 250 A1 Bedienungsanleitung

WARNING! RISK OF INJURY!
To avoid personal injury and damage to the appliance, never insert or
►
place your hands or any foreign objects into the feed tube.
Do not change accessories unless the drive is stationary and the mixer is
►
unplugged from the power supply! The appliance will run on for a short
time after being switched off !
Never leave the appliance unattended!
►
Before changing accessories or additional parts that are in motion during
►
operation, the appliance must be switched off and disconnected from
mains power.
Before fi rst use
■ Remove all packaging materials from the appli-
ance.
■ Clean the appliance as described in the section
"Cleaning and care".
■ Ensure that all parts are completely dry before
operating the appliance.

Assembling the appliance

NOTE
The appliance will not start until the bowl 5
►
and the lid 3 are correctly attached.
1) Place the motor unit 7 on a fl at surface so
that the sucker feet can attach fi rmly and the
appliance stands fi rmly in place.
2) Place the bowl 5 onto the motor unit 7
so that the arrow
towards the open lock symbol
motor unit 7. Then turn the bowl 5 until the
arrow points to the closed lock symbol
and the bowl 5 clicks into place.
If you want to work with the cutting blades, as-
semble the appliance as described in the section

"Cutting blades".

If you want to work with the food processing at-
tachments, assemble the appliance as described
in the section "Food processing attachments".
KM 250 A1
on the bowl 5 points
on the
Cutting blades
1) Place the cutting blades 4 onto the drive
shaft 6. The fl attened side of the drive shaft 6
must correctly fi t into the take up of the cutting
blades 4. Otherwise the cutting blades 4
cannot be properly attached.
2) Place the lid 3 onto the bowl 5 so that the
on the lid 3 coincides with the
arrow
arrow and the opened lock symbol
on the bowl 5.
3) Turn the lid 3 until the arrow
points to the arrow
on the bowl 5.
symbol
4) Place the pusher 1 into the feed tube 2.
5) Insert the plug into a mains power socket.
on the lid 3
and the closed lock
25
GB