Replacing Fuses - Welch Allyn 88000A Gebrauchsanleitung

30 Maintenance

Replacing Fuses

Two fuses are located in slots adjacent to the power supply cord receptacle on the side
of the power supply housing. This housing is attached to the pole of the video colposcope
stand.
1. To replace a blown fuse, remove the fuse holder by pressing the tab and pulling the
holder out of the power supply.
2. Pull out and remove the blown fuse from the fuse holder.
3. Replace with new fuses # T1.00L-250V 1A Time lag/Low Breaking Capacity
(Welch Allyn Part # 488307-9).
4. Reinsert the fuse holder by pressing until it snaps into place.
Tab
Welch Allyn Video Colposcope