Troubleshooting - Pulsar DIGIFORCE 860RT Handbuch

18

TROUBLESHOOTING

The table below lists some potential problems that may occur when using
the scope. If the problem experienced with the scope is not listed, or if the
suggested action does not resolve the problem, the unit should be
returned for repair.
Problem Check
Check that the batteries are
The unit will not turn
correctly fitted in the battery
on.
compartment.
Check battery operation.
Oxidized contacts in the
battery compartment due to
"leaky" batteries or contacts
have been exposed to
a chemically active liquid.
The unit does not Make sure your power
supply Is providing output
operate on external
voltage.
power supply.
Check that the eyepiece and
Poor image quality.
lens are adjusted
in accordance with the user
manual.
Make sure the lenses are not
misted or soiled.
The unit is beyond reliable
No Wi-Fi signal or
Wi-Fi range.
erratic signal.
There are obstacles between
the unit and the signal
receiver (concrete walls for
example).
Please restore the original
The unit is not
software version.
operating properly due
to software update.
17
Corrective action
Replace the batteries or fit the
batteries correctly.
Clean the battery
compartment,
clean the contacts.
Charge the external power
supply (if required).
Check that the USB cable is
intact.
Adjust the unit according in
accordance with the user
manual.
Clean the lenses with a cloth
moistened with alcohol.
Place the unit in line-of-sight of
the Wi-Fi signal.
1) Hold down simultaneously the
REC and ZOOM buttons.
2) Hold down the ON button (while
holding REC and ZOOM).
3) The green LED will blink twice,
then will start blink constantly:
the original software is being
installed.
4) Release REC and ZOOM.
5) Once software installation is
over, the LED is blinking with a 1
sec interval.
6) Disconnect the unit from the
power supply (remove the batteries
or disconnect an external power
supply).
18