Trouble Shooting - Parkside PTHSA 20-Li A1 Originalbetriebsanleitung

GB IE NI

Trouble Shooting

Problem
Device does not
start
Device works with
interruptions
Blade safety bar
(1) is getting hot
Bad cutting results
18
Possible cause
Rechargeable battery (15)
discharged
Rechargeable battery (15)
not inserted
Switch lock (10) has not
been activated properly
On/off switch (11) is broken
Worn out carbon brushes
Defective motor
Internal loose contact
On/off switch (11) is broken
Blade safety bar (1) is blunt
Blade safety bar (1) contains
nicks
Too much friction due to lack
of lubrication
Too much friction due to lack
of lubrication
Dirty blade safety bar
Blade safety bar (1) is blunt
Bad cutting technique
Rechargeable battery (15)
not fully charged
Troubleshooting
Charge the battery (15) (observe
the separate operating instructions
for the rechargeable battery and
charger)
Insert rechargeable battery (ob-
serve the separate operating
instructions for the rechargeable
battery and charger)
Switch it on (see 'Operation')
Repair by service centre
Repair by service centre
Sharpen or replace blade safety
bar (1) (service centre)
Check or replace the blade safety
bar (1) (service centre)
Lubricate the blade safety bar (1)
Lubricate the blade safety bar (1)
Clean the blade safety bar (1)
Have the blade safety bar (1) shar-
pened or replaced (service centre)
See 'Working with the device'
Charge the battery (15) (observe
the separate operating instructions
for the rechargeable battery and
charger)