Wiring According To Emc Requirements - Lenze 8200 motec Montageanleitung

`çåÇáíáçåë Ñçê íêçìÄäÉJÑêÉÉ çéÉê~íáçåW
bñÅÉéí Ñçê íÜÉ ã~áåë Å~ÄäÉI ìëÉ ëÜáÉäÇÉÇ Å~ÄäÉë çåäóK
qÜÉ ëÜáÉäÇ ãìëí ÄÉ Å~êÉÑìääó ÅçååÉÅíÉÇ íç mbK
pÉé~ê~íÉ Åçåíêçä ~åÇ ã~áåë Å~ÄäÉë Ñêçã ãçíçê Å~ÄäÉ>
`çååÉÅí ãçíçê ~åÇ ã~áåë mb ÅçåÇìÅíçêë íç ëÉé~ê~íÉ mb íÉêãáå~äëK
^
_
`
a
c
cáÖK S
Mains cable L1, L2, L3, PE

PE connection - mains cable

Use shielded motor cable (use low capacity motor cables)

EMC cable connection for motor cables

PE connection - motor cable

Shielded control cable

Shield connection for control cable (screw shield to shield sheet)

PE connection - terminal strip X2

Isolated terminal (e.g. star point for motor star connection)

Function module

X1 Terminal strip - mains connection
X2 Terminal strip - motor connection
PES HF shield connection by connecting the shield with a surface as large as possible to PE
L

Wiring according to EMC requirements

uN
b
d
EDK82MV222 DE/EN/FR 9.0
Wall mounting
Shield connection
1. Prepare cable
uO
e
2. Route the cable through
f
g
3. Tighten the screw. The
8200mot100
P
the eyebolt of the shield
and bend the eyebolt.
shield must be tightly
connected to the shield
sheet.
0.7 Nm
6 lb-in
PES
VR