Accessories; Minimising Wear And Preventing Damage - Viking MI 632 M Gebrauchsanleitung

Battery AAI 201:
for: MI 632 M
6309 400 6501

18. Accessories

Installation kits:
iKit S for mowing areas up to 500 m
6909 007 1011
iKit L for mowing areas from 2000 m
2
4000 m
6909 007 1012
Fixing pins AFN 075:
6301 007 1010
Perimeter wire ARB 501:
Length: 500 m
Diameter: 3,4 mm
0000 400 8625
Wire connector ADV 010:
6909 007 1090
Small-area module AKM 100:
6909 007 1016
Additional accessories are available for
the machine.
Further information is available from your
VIKING specialist dealer, on the internet
(www.viking-garden.com) or in the
VIKING catalogue.
For safety reasons, only
accessories approved by VIKING
may be used with the machine.
156
19. Minimising wear and
preventing damage
Important information on maintenance
and care of the product group
Robotic mower, battery powered
VIKING assumes no liability for material or
2
personal damage caused by the non-
observance of information contained in the
2
–
operating instructions, in particular with
regard to safety, operation and
maintenance, or which arise through the
use of unauthorised attachment or spare
parts.
Please always observe the following
important information for the prevention of
damage or excessive wear to your VIKING
machine:
1. Wearing parts
Some parts of the VIKING machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
– Mowing blade
– Battery
2. Compliance with the information in
this instruction manual
The VIKING machine must be used,
maintained and stored with the care
described in this instruction manual. Any
damage caused by non-compliance with
the safety, operating and maintenance
instructions is the sole responsibility of the
user.
This applies in particular to:
– incorrect handling of the battery
(charging, storage),
– incorrect electrical connection
(voltage),
– product modifications not approved by
VIKING,
– use of tools or accessories which are
not approved or suitable for the
machine, or are of inferior quality,
– improper use of the product,
– use of the product for sporting or
competitive events,
– resultant damage due to continued use
of the product with defective
components.
3. Maintenance operations
All operations listed in the section
"Maintenance" must be performed
regularly.
If these maintenance operations cannot be
carried out by the user, a specialist dealer
must be commissioned to perform them.
VIKING recommends that you have
maintenance operations and repairs
performed exclusively by a VIKING
specialist dealer.
VIKING specialist dealers regularly attend
training courses and are provided with
technical information.
If these operations are neglected, faults
may arise which are the responsibility of
the user.
These include:
– damage to the machine as a result of
inadequate or incorrect cleaning,
– corrosive and other resultant damage
caused by incorrect storage,
– damage to the machine through the use
of inferior-quality spare parts,
0478 131 9937 B - EN