Programming The Robotic Mower - Viking MI 632 M Gebrauchsanleitung

No ends following of the perimeter wire
and the next step of the installation
assistant is called up.
Recommendation:
Do not cancel the test run, as
important values gathered while
following the edge will not be
saved.
In addition, possible problems
when following the edge of the
mowing area or when docking may
not be recognised.
The test run can be repeated in the
iMow TeaM / TeaM Installations
menu following initial installation if
necessary. ( 11.6)
The robotic mower docks in the master
docking station again after one complete
circuit of the mowing area. Then a second
test run is started in the opposite direction.
Automatic completion of the test run:
The next step of the installation assistant is
called up when the robotic mower docks
following the second complete circuit.

9.16 Programming the robotic mower

Installed no-go areas and
secondary areas must not be
included when calculating the size
of the mowing area.
124
Enter the size of the lawn and
confirm with OK.
Calculating new mowing plan.
The procedure can be cancelled using the
red STOP button on the top of the
machine.
Confirm the message "Confirm each
day individually" by pressing the OK
button.
The active times for Monday are
displayed and the menu item
Confirm active times is enabled.
All the active times are confirmed
with OK and the next daily plan is
displayed.
The mowing plan can only be
changed with the iMow app.
In the case of small mowing areas,
not all the week days are used for
mowing. In this case, no active
times are displayed and the menu
item "Delete all active times" is
omitted. Days without active times
must also be confirmed with OK.
The mowing plan is displayed after
the active times for Sunday have
been confirmed.
0478 131 9937 B - EN