Operation; Switching On And Off; Battery Charge Level; Handling The Appliance - Parkside PMSA 12 B2 Originalbetriebsanleitung

♦ Proceed in reverse order to fit a new cutting
disc . Make sure that the ground side of the
cutting disc is facing outwards .
WARNING!
► If there is a direction of rotation arrow on
the cutting disc, it must match the direction of
rotation arrow on the appliance .
► Do not tighten the clamping screw
tightly . The cutting disc could break .

Operation

WARNING! RISK OF INJURY
► Note that the cutting disc runs on for a little
while .

Switching on and off

Switching on:
♦ Slide the On/Off switch
Switching off:
♦ Slide the On/Off switch

Battery charge level

♦ The status will be shown on the battery display
LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Handling the appliance

♦ Move the appliance forward slowly and without
exerting too much pressure .
♦ Make sure that the cutting disc does not come
to a standstill .
♦ Keep thin materials, such as fabric, under
tension while working them .

Cutting line marking

♦ Draw the desired pattern in advance on the
material you are working .
♦ Use the cutting line marking
self on the previously marked pattern .
■ 8 │ GB │ IE │ NI │ CY
too
to position 1 .
to position 0 .
to orient your-

Maintenance and cleaning

WARNING! RISK OF INJURY! Always
switch off the appliance and remove
the battery before carrying out any
work on the appliance.
The appliance is maintenance-free .
■ The appliance must always be kept clean, dry
and free from oil or grease .
■ Never allow liquids to get into the appliance .
■ Use a dry cloth to clean the housing . Never use
petrol, solvents or cleansers which can damage
plastic .
■ Always keep the area around the blade guard
clean . Remove dust and chips by blowing them
out with compressed air or with a brush .
■ If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level is
between 50% and 80% . The optimum storage
environment is cool and dry .
NOTE
► Replacement parts not listed (such as batter-
ies, battery charger) can be ordered via our
service hotline .

Disposal

The packaging is made from environmen-
tally friendly material and can be
disposed of at your local recycling plant .
Do not dispose of power tools in
your normal domestic waste!
European Directive 2012/19/EU requires that
worn-out power tools be collected separately and
recycled in an environmentally compatible manner .
Do not dispose of batteries in your
normal household waste!
PMSA 12 B2