Operation; Setting Up; Selecting The Speed; Checking The V-Belts - Parkside PTBM 400 A1 Originalbetriebsanleitung

GB IE

Operation

Caution!
Risk of injury!
- Ensure that you have sufficient space
in which to work and that you do not
endanger other people.
- All hoods and protective devices must
be assembled properly before commis-
sioning.
- Disconnect the mains plug before chan-
ging the setting on the device.

Setting up

Place the bench drill on a solid surface.
Bolt the machine to the substrate before
putting into operation. Use the four holes
in the baseplate (9) for this.
F

Selecting the speed

1. Release the locking bolt (3) on the gear
cover.
2. Open the gear cover (1).
3. Loosen the two locking nuts (4) of the
motor unit (5) with an open-ended
spanner (size 14 mm, not included in
delivery).
4. Push the motor unit (5) a little towards
the column tube (6) to relieve the V-belt
(35).
5. Place the V-belt (35) on the desired
combination to reach the specified
speed:
Ø (mm):
30
(U/min):
2650
1800
1300
900
600
6. Tighten the locking nuts (4) again and
tension the V-belt so that the motor unit
(5) presses backwards.
The V-belt (35) is correctly tensioned
when it can be pushed in about 1 cm.
7. Close the gear cover (1). Fasten the
locking bolt (3) on the gear cover .
The gear cover (1) is equipped with
a interlock switch (38). If the gear
cover (1) is not closed correctly, the
device cannot be switched on.
Recommended speeds for
different drill sizes and materials:
[mm]
< 3
3 - 4
5
6 - 8
> 8
F

Checking the V-belts

1. Release the locking bolt (3) on the gear
cover (1).
2. Open the gear cover (1).
3. Check the tension of the V-belt (35).
4. The V-belt (35) is correctly tensioned
when it gives way slightly when
pressed.
5. Check the V-belt (35) for tears, cuts or
other damage.
6. Close the gear cover (1). Fasten the
locking bolt (3) on the gear cover (1).
[mm] [1/min]
< 4
2650
5 - 6 1800
7 - 8 1300
9 - 10 900
> 10
600