Replacement Parts/Accessories; Troubleshooting; Error Correction - Parkside PTBM 400 A1 Originalbetriebsanleitung

Replacement parts/Accessories

Spare parts and accessories can be obtained at
If you do not have internet access, please contact the Service Centre via telephone
(see "Service-Center" page 37). Please have the order number mentioned below ready.
Position Position
Manual drawing
6 92,94
12 86-91,96
13 97-109
21 45
23 44
25 59-60
31 61
35 72
F
11-13
110

Troubleshooting

Problem
Device doesn't
start
Strong vibrations
Laser does not
work
Loud squeaking
noise
Description
Column tube
Drilling bench, complete
Vice
Drill chuck
Safety device, complete
Drill lift arm x 3
Drill chuck key
V-belt
Hinge of the gear cover
Laser
Possible Cause
No mains voltage
Main circuit breaker is
tripped
On switch (28) / off
switch (27) defective
Motor faulty
Motor unit (5) not fi xed
in place
Bit not centrally clamped
Batteries empty
V-belt tension is too high
Damaged V-belts (35)
Damaged pulley
www.grizzlytools.shop

Error correction

Check the socket, mains supply cable,
cord, mains plug; if necessary, have
them repaired by a qualifi ed electrician.
Check the main fuse
Repair by Customer Care
Repair by Customer Care
Check V-belt tension and tighten the lo-
cking nuts (4).
Check the bit in the drill chuck (21)
Replace batteries (see "Replacing laser
batteries")
Check V-belt tension
Check V-belts (35)
Check pulleys
GB IE
Ordernumber
91104521
91104522
91103342
91103343
91103336
91104525
91104510
91103345
91103346
91099350
35