Turning Off The Power - Christie LWU650-APS Bedienungsanleitung (Kurzform

Turning off the power

1.
Press the STANDBY/ON button on the projector
or the remote control.
The message "Power off?" appears on the screen
for about 5 seconds.
2.
Press the STANDBY/ON button again while the
message appears.
The light source will go off, and the POWER/
STATUS indicator will begin blinking in orange.
Then the POWER/STATUS indicator will stop
blinking and light in steady orange when the light
source cooling is completed.
3.
Attach the lens cover, after the POWER/STATUS
indicator turns to steady orange.
►Do not touch around the exhaust vents during use or just after use, since it is
too hot.
►Remove the power cord for complete separation. The power outlet should be
close to the projector and easily accessible.
NOTE • Power off the projector after any connected devices are powered off.
• This projector has the AUTO POWER OFF function that can make the projector turn
off automatically. For more information, see the Operating Guide. (1)
LWU650-APS/LWU530-APS
Setup Guide
WARNING
16
POWER/STATUS indicator
STANDBY/ON button
MYBUTTON
INPUT
1 2
STANDBY/ON
ASPECT PbyP AUTO
MAGNIFY FOCUS ZOOM
+ +
ON
- -
OFF
PAGE
UP GEOMETRY PICTURE
DOWN INTERACTIVE NETWORK
ESC
ENTER
OSD MSG
020-001521-02 Rev. 1 (01-2019)
LIT GUID SET APS Series
FREEZE
button
VOLUME
+
-
MUTE
BLANK
MENU
RESET