Displaying the picture
1.
Activate your signal source. Turn the
signal source on, and make it send the
signal to the projector.
2.
Use the VOLUME + / VOLUME -
buttons to adjust the volume. To turn off
the sound, press the MUTE button on
the remote control.
3.
Press the INPUT button on the projector
or the remote control. Select a desirable
input referring to the displayed input list.
4.
Press the ASPECT button on the remote
control. Each time you press the button,
the projector switches the mode for
aspect ratio in turn.
5.
Use the ZOOM ring to adjust the screen
size.
6.
Use the FOCUS ring to focus the picture.
7.
Fasten the ZOOM ring by STOPPER so
that it cannot loosen.
8.
Turn the VERTICAL adjuster fully
counter clockwise. Then turn it clockwise
and adjust the vertical lens position
upward.
9.
Turn the HORIZONTAL adjuster
clockwise or counter clockwise to adjust
the horizontal lens position.
►If you wish to have a blank screen while the light source is on, use the BLANK
function (see the Operating Guide (1)).
cause the damage on the projector. Blocking the beam by something causes
high temperature and could result in fire or smoke.
NOTE • The ASPECT button does not work when no proper signal is inputted.
• There may be some noise and/or the screen may flicker for a moment when an
operation is made. This is not a malfunction.
• For the details of how to adjust the picture, see
LWU650-APS/LWU530-APS
Setup Guide
FOCUS
ZOOM
INPUT
button
INPUT
ASPECT
MAGNIFY
ON
OFF
PAGE
UP
GEOMETRY
INTERACTIVE
DOWN
ESC
OSD MSG
WARNING
Taking any other action may
Operating
15
ring
ring
INPUT
button
MYBUTTON
1
2
VOLUME+ button
PbyP
AUTO
FREEZE
FOCUS
ZOOM
VOLUME
+
+
+
VOLUME- button
-
-
-
PICTURE
MUTE
MUTE button
NETWORK
BLANK
MENU
ENTER
HORIZONTAL adjuster
RESET
VERTICAL adjuster
Guide. (1)
020-001521-02 Rev. 1 (01-2019)
LIT GUID SET APS Series
STOPPER