Adjusting The Projector's Elevator - Christie LWU650-APS Bedienungsanleitung (Kurzform

Adjusting the projector's elevator

Lengthening or shortening the each elevator foot shifts the projection position and
the projection angle.
Turn the elevator foot to adjust its length.
When the place to put the projector is slightly
uneven to the left or right, use the rear elevator
feet to place the projector horizontally.
Spacers are installed on each rear elevator feet
at the time of shipment, and the projector is ready
for use as it is.
If necessary, detach the spacer, and the elevator
foot can be manually twisted to make more
precise adjustments.
►Do not lengthen the
25 mm. The foot lengthened exceeding the
limit may come off and drop
down, and result in an injury or damaging the
projector.
►Keep the spacer away from children and pets.
Be careful not to let them swallow the spacer.
If swallowed consult a physician immediately
for emergency treatment.
NOTE •
You can attach the spacers to set the projector back to the factory default
after adjusting the foot. If you install the projector in a different place in the future, it is
recommended to keep the spacers and reuse them.
LWU650-APS/LWU530-APS
Setup Guide
WARNING
elevator feet exceeding
the projector
max.
25
Spacer
14
Front foot
mm
Rear feet
020-001521-02 Rev. 1 (01-2019)
LIT GUID SET APS Series