How To Connect/Remove External Dust Extraction; Adjusting The Oscillation Rate; Switching On/Off; Practical Tips - Parkside PSS 250 C3 Originalbetriebsanleitung

How to connect/remove
external dust extraction
Connecting external dust
extraction:
1. Push the external dust extraction adap-
tor (10) as far as it will go on the dust
extraction connector (12).
2. Connect the extraction hose from a
vacuum cleaner (sold separately) to the
external dust extraction adaptor (10).
Removing external dust
extraction
1. Remove the extraction hose from the
external dust extraction adaptor (10).
2. Disconnect the adapter for external
dust extraction (10).
If necessary, you can connect the
suction tube of a vacuum cleaner
directly to the device without an
adapter.
Adjusting the
oscillation rate
You can set the oscillation rate variable via
the oscillation rate selector (8).

Switching on/off

Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type plate.
Turn the machine on before you ap-
proach the material to be sanded.
Connect the machine to the power
supply.
Switching on:
Push the On/off switch (2) forwards. The
device turns on.
Switching off:
Pull the On/off switch (2) backwards. The
device turns off. Caution: The sanding plate
(7) continues to oscillate for a short time.
Wait until the plate (7) comes to a standstill.

Practical tips

When working with the ap-
pliance, always wear suit-
able clothing and appropriate
protective equipment. Prior to
each use it must be ensured
that the appliance is working
correctly. Personal protective
equipment and a fully func-
tional appliance reduce the
risk of injuries and accidents.
Do not use the device without a dust
collection box or external dust extrac-
tion. Use of a dust extraction can
reduce hazards caused by dust.
When using sanding sheets without
ventilation holes, dust extraction is not
possible. Make sure that the work-
place is well ventilated.
Pull the mains plug before any ad-
justments, maintenance or repair.
Danger of electric shock.
• Move the appliance against the work-
piece once it is switched on.
• After machining, lift the sanding plate up
before turning off the device.
• Always lead the mains cable towards the
back and away from the device.
• Clean the sanding plate before attaching
a sanding sheet.
GB IE NI
11