Connecting/Removing/Emptying The Dust Collection Box; How To Connect/Remove External Dust Extraction - Parkside PHS 160 E5 Originalbetriebsanleitung

G B IE NI
above the extraction openings
(15) of the sanding plate (10).
Removing sanding sheet:
2. Pull the sanding sheet (12) from
the sanding plate (10).
Only perform sanding once both
sanding sheets are mounted.
Mounting sanding finger
You can replace the pre-mounted sanding
vided in the scope of delivery.
Unmounting sanding plate:
1. Open the clamping lever (16)
and turn it in the direction of the
sanding sheet until it reaches the
stop.
2. Remove the front section of the
sanding plate (10).
Inserting sanding finger:
3.
from above against the back
section of the sanding plate (10)
4.
(16) into its original position.
Attaching sanding sheet for san-
ding finger:
5. Press the sanding plate for the
6. Place a sanding sheet onto the
back section of the sanding plate
.
the Velcro.
1 0
3 -
3
.
4
3 .
Connecting/removing/empty-
ing the dust collection box
Connecting the dust collection box:
1. Before connecting, ensure that the
closed.
2. Press the release button (4) on the
dust collection box (8). Slide the
dust collection box (8) all the way
onto the connection for dust ex-
the connection for dust extraction
the dust collection box (8).
3. Let go of the release button (4). It
xing pin of the dust collection box
(8).
Removing the dust collection box:
4. Press the release button (4) and
pull the dust collection box (8) out.
Emptying the dust collection box:
5. Pull the tab (7) and remove the
dust collection box lid (6).
.
out the dust collection box (8).
.
(8) again.
Empty the dust collection box regu-
larly to ensure optimal suction.
How to connect/remove
external dust extraction
Connecting external dust
extraction
1. Push the external dust extraction
adaptor (11) as far as it will go
on the dust extraction connector
(9).
8
.
8
-