Connecting/Removing/Emptying The Dust Collection Box; How To Connect/Remove External Dust Extraction; Operation; Switching On/Off - Parkside PMS 160 A1 Originalbetriebsanleitung

Connecting/removing/
emptying the dust col-
lection box
Connecting the dust collection
box:
1. Before connecting, ensure that the dust
collection box (8) is fi rmly closed.
2. Slide the dust collection box (8) all the
way onto the dust extraction connector
(4). Pay attention to the guide rollers
(16) on the dust extraction connector
(4).
3. Turn the dust collection box (8) clock-
wise to fasten.
Removing the dust collection
box:
4. Turn the dust collection box (8) coun-
ter-clockwise to undo.
5. Remove the dust collection box (8).
Emptying the dust collection
box:
6. Push the tab (9) on the dust collection
box (8) and remove the dust collection
box lid (7).
7 To empty, simply shake or knock out
the dust collection box (8).
8. Then close the dust collection box (8)
again.
Empty the dust collection box regu-
larly to ensure optimal suction.
How to connect/remove
external dust extraction
Connecting external dust
extraction
1. Push the external dust extraction
adaptor (10) as far as it will go
on the dust extraction connector
(4).
GB
A suitable vacuum cleaner must
be used (e.g. a workshop vacuum
cleaner). Normal household vacu-
um cleaners are not intended for
vacuuming sanding material. This
information can be found in the
operating instructions of the exter-
nal device.
2. Connect the extraction hose from
a vacuum cleaner (sold separate-
ly) to the external dust extraction
adaptor (10).Make sure that the
dust extraction system is suitable
for the material to be cut.
Removing external dust extraction
1. Remove the extraction hose
from the external dust extraction
adaptor (10).
2. Disconnect the adapter for exter-
nal dust extraction (10).
If necessary, you can connect the
suction tube of a vacuum cleaner
directly to the device without an
adapter.

Operation

Switching on/off

Make sure that the power supply
voltage matches the voltage rat-
ing indicated on the device's type
plate.
Connect the machine to the power
supply.
1. To switch on, fl ick the on/off
switch (1) to position „I". The
tool will power on.
IE NI CY
11