Practical Tips; Sanding; Selection Of Sanding Sheet; Choosing The Right Sanding Plate - Parkside PMS 160 A1 Originalbetriebsanleitung

GB IE NI
2. To switch off, fl ick the on/off
switch (1) to position „0". The
tool will power off.

Practical tips

When working with the ap-
pliance, always wear suita-
ble clothing and appropriate
protective equipment.
Prior to each use it must be
ensured that the appliance is
working correctly.
Personal protective equip-
ment and a fully functional
appliance reduce the risk of
injuries and accidents.
Do not use the device without a
dust collection box or external dust
extraction. Use of a dust extraction
can reduce hazards caused by
dust.
When using sanding sheets without
ventilation holes, dust extraction
is not possible. Make sure that the
workplace is well ventilated.
Pull the mains plug before any ad-
justments, maintenance or repair.
Danger of electric shock.

Sanding

• Move the appliance against the work-
piece once it is switched on.
• After machining, lift the sanding disc
up before turning off the device.
• Always lead the mains cable towards
the back and away from the device.
• Clean the sanding plate before you at-
tach a sanding sheet.
• Only work with sanding sheets in per-
12
CY
fect condition to achieve good sanding
results.
• Work with low and even pressure on
the hand rest (
pressure. This protects the appliance
and the sanding sheet.
• Grind rough corners and edges with
the top or side edge of the sanding
sheet.
If the front tip of the triangular sanding
sheet is worn, the sanding sheet can
be removed, rotated and put back into
place.
• Do not use the same sanding sheet to
sand different materials (e.g. metal
and then wood).
• Empty the dust collection box or the
vacuum cleaner regularly in order to
ensure optimal suction.

Selection of sanding sheet

Grain size Application
P 60 for pre-sanding rough wood
P 80
surfaces
P 120
for plain sanding
P 180
for fi ne sanding of primed and
P 240
painted surfaces
Choosing the right sanding
plate
Pre-mounted sanding plate:
• For sanding/grinding large surfaces
as well as corners, edges and outer
curves.
Sanding fi nger:
• For machining small slots and narrow
intermediate spaces.
2) and even forward