Operation; Switching On/Off; Practical Tips; Sanding - Parkside PHS 160 E5 Originalbetriebsanleitung

2. Connect the extraction hose from
a vacuum cleaner (sold separate-
ly) to the external dust extraction
adaptor (11).
Removing external dust extraction
1. Remove the extraction hose
from the external dust extraction
adaptor (11).
2. Disconnect the adapter for exter-
nal dust extraction (11).
If necessary, you can connect the
suction tube of a vacuum cleaner
directly to the device without an
adapter.

Operation

Switching on/off

Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type plate.
Connect the machine to the power
supply.
.
switch (1) to position
will power on.
2.
switch (1) to position
tool will power off.

Practical tips

When working with the ap-
pliance, always wear suita-
ble clothing and appropriate
protective equipment.
Prior to each use it must be
ensured that the appliance is

Sanding

• Move the appliance against the work-
piece once it is switched on.
• After machining, lift the sanding disc
up before turning off the device.
• Always lead the mains cable towards
the back and away from the device.
• Clean the sanding plate before you at-
tach a sanding sheet.
I .
• Only work with sanding sheets in per-
fect condition to achieve good sanding
results.
0 .
• Work with low and even pressure and
the appliance and the sanding sheet.
• Grind rough corners and edges with the
top or side edge of the sanding sheet.
If the front tip of the triangular sanding
sheet is worn, the sanding sheet can
be removed, rotated and put back into
place.
• Do not use the same sanding sheet to
sand different materials (e.g. metal
G B
working correctly.
Personal protective equip-
ment and a fully functional
appliance reduce the risk of
injuries and accidents.
Do not use the device without a dust
collection box or external dust extrac-
tion. Use of a dust extraction can
reduce hazards caused by dust.
When using sanding sheets without
ventilation holes, dust extraction
is not possible. Make sure that the
workplace is well ventilated.
Pull the mains plug before any ad-
justments, maintenance or repair.
Danger of electric shock.
IE NI
.
1 1