Using An Extension Cable; Installing And Removing The Battery Pack - DeWalt DCB090 Bersetzt Von Den Originalanweisungen

Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be made to the earth
terminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 3 A.

Using an Extension Cable

An extension cord should not be used unless absolutely necessary.
Use an approved extension cable suitable for the power input of your
charger (see Technical Data). The minimum conductor size is 1 mm
the maximum length is 30 m.
When using a cable reel, always unwind the cable completely.
OPERATION

Installing and Removing the Battery Pack

(fi g. 1, 2)
NOTE: Make sure your battery pack is fully charged.
IMPORTANT: To avoid battery charge depletion, remove the battery
pack from the DCB090 USB charging battery adapter when not in use.
TO INSTALL BATTERY PACK
Slide the battery pack (a) into the DCB090 USB charging battery
adapter (b) until the battery pack is firmly seated.
WARNING: Fire hazard. Do not store or carry the
battery pack so that metal objects can contact
exposed battery terminals.
E NGLI SH
2 ;
51