Electrical Safety; Using An Extension Cable - DeWalt DCB115 Originalanweisungen

EngLIsh

WARNING! Read all safety warnings and all instructions. Failure to follow the
warnings and instructions may result in electric shock, fire and/or serious injury.
SAVE ALL WARNINGS AND INSTRUCTIONS

Electrical Safety

The electric motor has been designed for one voltage only. Always check that the battery
pack voltage corresponds to the voltage on the rating plate. Also make sure that the
voltage of your charger corresponds to that of your mains.
Your D WALT charger is double insulated in accordance with EN60335; therefore
e
no earth wire is required.
If the supply cord is damaged, it must be replaced by a specially prepared cord available
through the D WALT service organisation.
e
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in the plug.
• Connect the blue lead to the neutral terminal.

WARNING: No connection is to be made to the earth terminal.
Follow the fitting instructions supplied with good quality plugs. Recommended fuse: 3 A.

Using an Extension Cable

An extension cord should not be used unless absolutely necessary. Use an approved
extension cable suitable for the power input of your charger (see Technical Data). The
minimum conductor size is 1 mm
When using a cable reel, always unwind the cable completely.
Important Safety Instructions for All Battery Chargers
SAVE THESE INSTRUCTIONS: This manual contains important safety and operating
instructions for compatible battery chargers (refer to Technical Data).
• Before using charger, read all instructions and cautionary markings on charger, battery
pack, and product using battery pack.

WARNING: Shock hazard. Do not allow any liquid to get inside charger. Electric shock
may result.
30
FOR FUTURE REFERENCE
2 ; the maximum length is 30 m.