Vacuum-Packing And Sealing Bags (Without Valves) - Silvercrest SV 125 B2 KAT Bedienungsanleitung

3. Place the bag in the device. For this pur-
pose, the end of the film bag must be
positioned just before the rear reference
ridges 13 and the side reference ridg-
es 15.
4. Ensure again that there are no creases
in the film bag - especially in the area
above the welding wire 17.
5. Close the lid 12.
6. Use both hands to press firmly on the
edges of the lid 12. They must audibly
click into place.
7. Press the button
up. The film bag is being sealed.
After approx. 5 - 7 seconds, the LED
goes out and the sealing process is com-
pleted.
NOTE: If you have activated the Wet
function, the sealing process takes a few sec-
onds longer.
8. Simultaneously, press buttons 9 in order
to release the lock of the lid 12.
9. Open the lid 12 and remove the bag.
10. Check the welding seam. It should be a
smooth creaseless seam.
3. The LED lights
1
8.7 Vacuum-packing and
sealing bags (without
valves)
DANGER! Risk of electric
shock due to moisture!
For vacuum-packing, no liquids must be
inside the bag.
Ensure that no liquid is sucked in during
the extraction of air. If this nevertheless
occurs, immediately interrupt the pro-
cess by pressing the active function but-
ton 4 again.
NOTE: When vacuum-packing film bags,
there must not be any vacuum tube 19
plugged into the connection 8.
1. Smooth the bag where it is to be
sealed.
2. Open the lid 12.
3. Place the bag in the device. For this pur-
pose, the end of the film bag must be
positioned just before the rear reference
ridges 13 and the side reference ridg-
es 15.
4. Ensure again that there are no creases
in the film bag - especially in the area
above the welding wire 17.
5. Close the lid 12.
11
GB