Filling Bags (Without Valves); Sealing Bags (Without Valves); Vacuum-Packing And Sealing Bags (Without Valves) - Silvercrest SV 125 A1 Bedienungsanleitung

3. Place the vacuum bag flat on a level
surface with the valve pointing up-
wards.
4. Proceed as for vacuum containers, start-
ing at step 2 (see "Vacuum containers"
on page 9).
8.3 Filling bags (without
valves)
CAUTION:
No food or liquids must be present at
the top edge, where you want to seal
the bag. That area must be clean and
dry. Otherwise, it is impossible to pro-
duce a proper welding seam.
• Fill the bag only up to a level of 6 cm
below the top edge.
8.4 Sealing bags (without
valves)
1. Smooth the bag where it is to be
sealed.
2. Open the lid 10. If necessary, press the
buttons 7 first.
3. Place the bag in the device. For this pur-
pose, the end of the film bag must be
positioned just before the rear reference
ridges 11 and the side reference ridg-
es 13.
4. Ensure again that there are no creases
in the film bag - especially in the area
above the welding wire 15.
10 GB
5. Close the lid 10.
6. Use both hands to press firmly on the
edges of the lid 10. They must audibly
click into place.
7. Press the button
up. The film bag is being sealed.
After approx. 5 - 7 seconds, the LED
goes out and the sealing process is com-
pleted.
8. Simultaneously, press buttons 7 in order
to release the lock of the lid 10.
9. Open the lid 10 and remove the bag.
10. Check the welding seam. It should be a
smooth creaseless seam.
8.5 Vacuum-packing and
sealing bags (without
valves)
DANGER! Risk of electric
shock due to moisture!
For vacuum-packing, no liquids must be
inside the bag.
Ensure that no liquid is sucked in during
the extraction of air. If this nevertheless
occurs, immediately interrupt the pro-
cess by pressing the active function but-
ton 3 again.
NOTE: when vacuum-packing film bags,
there must not be any vacuum tube 17
plugged into the connection 6.
1. Smooth the bag where it is to be
sealed.
2. Open the lid 10.
3. Place the bag in the device. For this pur-
pose, the end of the film bag must be
2. The LED lights