Mounting Of Protector - Dolmar MS-4300.4 R Originalbetriebsanleitung

MOUNTING OF PROTECTOR

To meet the applicable safety provisions, only the tool/protector combinations as indicated in the table must be used.
CAUTION:
The appropriate protector must always be installed, for
●
your own safety and in order to comply with accident
prevention regulations.
Operation of the equipment without the guard being in
place is not permitted.
Do not apply other combination when using saw-blade.
NOTE:
The standard combination of cutting tool differs from
●
county to country.
For metal blades
CAUTION:
Make sure that the protector tightening bolts are tightened evenly so that
●
the gap between the clamp and the protector will be constant.
Otherwise, the protector sometimes may not function as specified.
(For Type A protector)
Fix the protector (3) to the clamp (2) with two bolts M6x30 (1).
(For Type B protector)
Fix the protector to the clamp (4) with two bolts M6x18 (5).
If the protector cover (6) is installed on the shaft, remove it first as follows.
1. Remove the washers (7), bolts M6x30 (8) from protector cover.
2. Remove the protector cover by slightly spreading the fin (9).
NOTE:
When changing the protector from Type B to Type A, install the protector
●
cover, bolts M6x30 and washers onto the shaft before installing the
protector.
Protector for metal blade
Type A
Nylon cutting head
(5)
(8)
(6)
(7)
11
Metal blade
Protector for
nylon cutting head
Type A
(1)
(2)
(3)
(4)
(9)
Type B