Instructions For Use - Whale SH2202 Installations- Und Gebrauchsanweisung

Retail Installation - SH2202
The Whale® Space Heater comes fitted with a 3 pin plug. The socket must be mounted vertically and away from
potential exposure to water. If installation of an electrical socket is required, this must be carried out by a competent
person. The plug is fitted with a 10 amp fuse.
Please note: If the supply cable is damaged, it must be replaced by the caravan/motorhome/cable manufacturer or
a Whale® Approved Service Centre or Technician.
Warning: The appliance must not be supplied through an external switching device, such as a timer or a circuit that
is regularly switched. This is to avoid an inadvertent resetting of the thermal cut out.
N.B. Ensure that the Space Heater is not located immediately below the electrical supply socket.
Completed installation
Fig. 32 Completed Internal Installation
Please note: After completing the installation, carry out a full function check including gas soundness to ensure the
appliance has been installed and operates correctly. The gas soundness check must be carried out by an accredited
LPG gas engineer and a test certificate issued.
7.

INSTRUCTIONS FOR USE

To the User:
Read the following instructions carefully.
Observe all warnings.
In the unlikely event of leaks in the gas system, or if there is a smell of gas:
- Extinguish all naked flames
- Do not operate any electrical switches
- Turn off all gas appliances
- Open windows and doors for ventilation
- Do not smoke
- Shut off gas connection
Ensure that the system is thoroughly checked by a Whale® Approved Service Centre or Whale Service Engineer.
Fig. 31 Mains Connection
Fig. 33 Completed Underfloor Installation
17