Whale SH2202 Installations- Und Gebrauchsanweisung Seite 16

Retail Installation - Part Number SH2202
The Space Heater and Control Panels come complete with electrical connectors fitted.
Step i
Connect the 12 way electrical connector with the unattached red and white leads to the 12 way connector on the
Space Heater.
Step ii
Route the wire to the Control Panel and connect the 6 way electrical connector to the 6 way connector.
Step iii
Route the 3 way electrical connector to the 3 way connector at the Control Panel.
Step iv
Secure the wire close to the Control Panel ensuring that there is no strain on the wires at the switches.
Step v
Connect the free red lead coming from the 12 way connector to a 12V d.c. supply, then connect the free white lead to
the caravan 0V d.c. supply.
Please note: Whale recommends that a 5 amp automotive fuse is fitted in the 12V d.c. supply.
Space Heater
Hot Air Duct
12 Way Connector
Cold Air Inlet
Cold Air Duct
Vehicle Floor
Hot Air Outlet
12 Way Connector
Hot Air Outlet
Cold Air Inlet
Vehicle Floor
Fig. 28 Internal Installation - Connect 12V d.c. Fig. 29 Underfloor Installation - Connect 12V d.c.
Step 12 Electrical Connection 230V
The appliance must be installed in accordance with the installation instructions and comply with any relevant
regulations in the country where the appliance is installed. Electrical installation must be carried out by a suitably
qualified electrician. The electrical supply must be connected to a 13 amp fused spur provided with an all-pole
disconnection and the appliance must be earthed.
Vehicle Manufacturer Installation - Part Number: SH2212B
The mains supply cable is supplied with a JST LP series socket (terminal pins are JST slm-61T-2.0) and must be
mounted in a housing with strain relief to prevent accidental disconnection and prevent access to the connector.
Protective Cover
Protective Cover Lid
Space Heater Wiring Loom
Fig. 30 Mains Electrical Connection
16