Instructions For Use - Whale SH2201 Montageanweisungen

Completed installation
Fig. 35 Completed Internal Installation
Please note: After completing the installation, a full function check including gas soundness must be carried out to
ensure the appliance has been installed and operates correctly. The gas soundness check must be carried out by an
accredited LPG engineer and a test certificate issued.
7. INSTRUCTIONS FOR USE
To the User:
Read the following instructions carefully.
Observe all warnings.
In the unlikely event of leaks in the gas system, or if there is a smell of gas:
- Extinguish all naked flames
- Do not operate any electrical switches
- Turn off all gas appliances
- Open windows and doors for ventilation
- Do not smoke
- Shut off gas connection
Immediately ensure that the system is thoroughly checked by a Whale® Approved Service Centre / Technician.
The Space Heater must not be operated in the following situations:
• When refuelling the vehicle or refuelling the vehicle towing the caravan or refuelling any other
appliances.
• When the vehicle in which the Space Heater is installed is in motion. Please refer to Section 3
(Application) in this document (unless a Vehicle in motion kit is fitted - see Appendix).
• When the vehicle in which the Space Heater is installed is in a confined space (such as a garage).
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Ensure that a minimum of one of the hot air outlet vents is permanently open.
When using gas, the combustion air inlet flue and outlet openings for the products of combustion (exhaust flue) must
never be obstructed. They must be checked regularly and if necessary cleaned by the user (e.g. in winter, snow or
fallen leaves must be removed from the combustion outlet and air intake).
Fig. 36 Completed Underfloor Installation
19