Duplicate Keys - Ducati SportClassic 1000 Anleitung- Und Instandhaltungsheft

Operation
When the ignition key is turned to OFF, the immobilizer
inhibits engine operation. When the ignition key is turned
back to ON to start the engine, the following happens:
1) if the CPU recognised the code, the light (6, fig. 4) on
the instrument panel will flash briefly. This means that
the immobilizer system has recognised the key code
and enabled engine ignition. Press the START button
(2, fig. 13), to start the engine;
2) if light (6, fig. 4) or EOBD light (7, fig. 4) stay on, it
means that the code was not acknowledged. When
this is the case, turn the ignition key back to OFF and
then to ON again. If the engine still does not start, try
with another black key. If the other key does not work
out either, contact the DUCATI Service network.
3) Should the pilot light (6, fig. 4) still be flashing, it
means that an immobilizer system fault was reset
(e.g. with the overriding procedure through throttle
grip). Turn the key to OFF and back to ON, the
immobilizer pilot light should go back to its normal
operation (see step 1).
Warning
Any important shock might damage the electronic
components fitted into the key.
Use only one key during the procedure. Failure to do so
might prevent the system from recognising the code of
the key in use.

Duplicate keys

If you need any duplicate keys, contact the DUCATI
Service network with all the keys you have left and your
CODE CARD.
DUCATI Service will program new keys and reprogram
your original keys, up to 8 keys in total.
You may be asked to identify yourself as the legitimate
owner of the motorcycle. Be sure you have any
documents you might need to this end ready.
The codes of any keys not submitted will be wiped off
from the memory to make those keys unserviceable in
case they have been lost.
Note
If you sell your motorcycle, do not forget to give all
keys and the CODE CARD to the new owner.
E
17