Procedure To Disable Immobilizer Engine Block Through Throttle Twistgrip - Ducati SportClassic 1000 Anleitung- Und Instandhaltungsheft

Procedure to disable immobilizer engine block
through throttle twistgrip
1) Turn the key to ON and fully open throttle. Keep it
open.
The EOBD warning light (7, fig. 4) turns off after 8
seconds.
2) Release the throttle as soon as the EOBD warning
light turns off.
3) EOBD pilot light will flash. It is now necessary to enter
E the electronic code indicated on the CODE CARD
delivered to the customer together with the bike.
4) Count as many flashes of the EOBD pilot light (7, fig.
4) as the first digit of the electronic code.
Fully open the throttle for 2 seconds, and release. In
this way the input of one figure is acknowledged,
EOBD pilot light comes on and stays on for 4 seconds.
Carry out the same procedure for the following figures
of the code. Failure to comply with this procedure, the
EOBD pilot light will flash for 20 times, then will come
on steady. Repeat the procedure starting from step
(1).
5) Release the throttle twistgrip, if the code is correct,
the EOBD warning light shall flash signalling that
engine block has been disabled. The warning light
turns off after 4 seconds.
6) If the code is NOT correct, the EOBD warning light
stays on and it is then possible to turn the key to OFF
and repeat the procedure, starting from point (1), as
many times as necessary (infinite).
16
Note
Should the throttle twistgrip be released before
the set time, the warning light turns on again.
It is then necessary to bring the key to OFF and restart the
procedure from point (1).