Initial Start-Up; Start-Up; Functions; Select Setting Level - Truma CP plus Gebrauchsanweisung

Initial start-up

In order to perform the initial start-up, the following steps are
required:
– Switch on the power supply.
12 V direct voltage for Truma CP plus control panel and
Combi and 230 V mains voltage for air conditioning sys-
tems and Combi E.
– Start the search of the appliances under the menu item
"Service menu" -> "RESET" -> "PR SET".
After confirmation,the Truma CP plus control panel initialises
itself. "INIT .." appears on the display while this is in progress.
This stores the appliances that have been found in the
Truma CP plus control panel .

Start-up

Start / stand-by screen
After connecting the Truma CP plus control panel to the pow-
er supply, a start screen is displayed after a few seconds.
– The display changes between the time and the set
room temperature.
– Special displays on command via Truma App,
IR remote control of the air conditioning system or
CI BUS (see "Special displays" on page 33).
– After a repair / retrofit, the procedure described under
"Initial start-up" must be repeated.
24 EN

Functions

The functions in the menu bars (3, 4) of the Truma CP plus
control panel can be selected in any order. The operating
parameters are shown on the status bar (2) and on the dis-
plays (5, 6).

Select setting level

– Tap the rotary push button.
The display shows the setting level. The first icon flashes.

Switching on/off

Switching on
– Tap the rotary push button.
– Previously set values / operating parameters are reac-
tivated after switching on.
Switching off
– Press the rotary push button for longer than 4 seconds.
– "APP" appears in the display after 2 seconds.
1
– "OFF" appears after another 2 seconds.
– The Truma CP plus control panel plus deactivation pro-
cedure may be delayed by several minutes because of
internal heating or air conditioning system after-runs.
1 Only in conjunction with a Truma iNet Box.