How To Get Started - MIRKA AROP-B 312NV Bedienungsanleitung

en
LED indication of 10.8 V charger
LED
3
2
1
Pre-charge
(Trickle charge)
Remain continuously on
Charger diagnostics
The charger will indicate if:
• A battery pack is overheated All three charging lights will flash Remove the battery and allow it to cool down for
15–30 minutes and re-insert
• A malfunction occurs in the battery or the charger Two charging lights will flash Remove the battery and allow it to
cool down Re-insert the battery pack into the charger If two charging lights still flash, the battery or charger may
require service

How to get started

• When unpacking the tool, make sure it is intact, complete and has not been damaged in transport Never use a
damaged tool
• Before use, check that the backing pad is correctly mounted
• Install the fully charged battery pack into the polisher until it locks in place with a click
Operating instructions
• The tool is intended to be operated as a hand-held tool The tool can be used in any position
• Select a suitable polishing pad and secure it to the backing pad Make sure the polishing pad is centered on the
backing pad
• The polisher can now be activated / turned on and started by pressing the switch trigger
• The polisher will run and stay in active mode as long as the trigger is pressed After the trigger is released the polisher
will stop but continue to stay in active mode for a short time before it automatically deactivates / turns off
• When polisher is in active mode the right LED is green
• If an intelligent battery is used all three LEDs will flash green for three seconds during startup
• In active mode the left LED shows the battery status:
– Green: Battery charge level is OK
– Flashing green: Battery charge level is below 75%
– Flashing green/red: Battery charge level is below 50%
– Flashing red: Battery charge level or battery health (only available if intelligent battery is used) is under 25%
– Red: Battery voltage too low polisher is not operable
AROP-B: 4,000–7,000 rpm. The speed can be adjusted between 4,000 and max rpm by adjusting the position of the
trigger In active mode the max rpm can be adjusted by pressing rpm+ or rpm–, Figure 1 The rpm can be adjusted in
steps of 4,000, 4,500, 5,000, 5,500, 6,000, 6,500 and 7,000 rpm
ARP-B: 1,500–2,200 rpm. The speed can be adjusted between 1,500 and max rpm by adjusting the position of the
trigger In active mode the max rpm can be adjusted by pressing rpm+ or rpm–, Figure 1 The rpm can be adjusted in
steps of 1,500, 1,600, 1,700, 1,800, 1,900, 2,050 and 2,200 rpm
62
Mirka® AROP-B 312NV & ARP-B 300NV • 77 mm (3") • 10.8 V
Charging... Charging...
Flashing
Charging finished Over temperature Battery failure