MIRKA AROP-B 312NV Bedienungsanleitung Seite 260

en | us • ca
Bluetooth
This tool is equipped with Bluetooth low energy technology and can be connected to an App from which additional
tool functionality can be accessed For more information on the App functionality and if it is available in your country,
go to www mirka com
Activate Bluetooth on your Mirka® AROP-B and Mirka® ARP-B as follows:
1 Connect the battery to the tool
2 Press and hold the rpm+ button while activating the tool by pressing the switch trigger
3 Middle LED is flashing green, to indicate that Bluetooth is active and ready for connections
4 Middle LED is lit green when the tool is connected to another Bluetooth device
5 Bluetooth is deactivated when the tool is deactivated/turned off
NOTE! If the App is not installed or if it is not available in your country, Bluetooth shall not be activated
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc and any use of such
marks by Mirka Ltd is under license Other trademarks and trade names are those of their respective owners
Compliance with the radio regulations in North America has been verified in accordance with FCC Part 15 subpart B
and C, RSS-GEN, RSS-247 and FCC §15 247
Maintenance
Always remove the battery before maintenance!
Only use original Mirka spare parts!
Replacing the backing pad
1 Hold the spindle with the pad wrench
2 Turn the backing pad counter-clockwise to remove it
3 Fit and tighten the new backing pad using the pad wrench
Cleaning
Use a soft brush to remove any accumulated dust Wear safety glasses to protect your eyes while cleaning If the body
of the tool needs cleaning, wipe it with a soft damp cloth A mild detergent can be used
WARNING: Never use alcohol, gasoline or other cleaning agent Never use caustic agents to clean plastic
parts
Charger cleaning instructions
Dirt and grease may be removed from the exterior of the charger using a cloth or soft non-metallic brush Do not use
water or any cleaning solutions
Further service
Service must always be performed by trained personnel To keep the tool warranty valid and ensure optimal tool safety
and function, service must be carried out by a Mirka authorized service center To locate your local Mirka authorized
service center, contact Mirka Customer service or your Mirka dealer
260
Mirka® AROP-B 312NV & ARP-B 300NV • 77 mm (3") • 10.8 V