Charging The Battery; Connecting The Power Supply And Battery Charger - Ottobock C-Leg 3C98-3 Gebrauchsanweisung

Accessories
The following components are not included in the scope of delivery and may be ordered separ­
ately:
• 3S26 cosmetic foam cover
• 4P862 C-Leg guard
• 4X860=* C-Leg Protective Cover (w/o shield)
• 4P863* Shield Insert
• 4X156 Charger Extension Cable – Ankle
• 4X158 charger extension cable – ankle, long
• 4X157 Charger Extension Cable – Knee

6 Charging the battery

The following points must be observed when charging the battery:
• With uninterrupted walking, the capacity of the fully charged battery is sufficient for at least 16
hours. It lasts about 2 days with average use.
• We recommend charging the product every day when used on a daily basis.
• When used daily, the complete charging unit (power supply – battery charger) may remain
plugged into the wall socket.
• For the maximum operating time with one battery charge, disconnecting the battery charger
from the product only immediately before using the product is recommended.
• The battery should be charged until the yellow LED on the battery charger turns off prior to
initial use, and for at least 4 hours. This calibrates the charge level indicator via the Cockpit
app and by turning over the prosthesis.
If the battery charger is disconnected from the prosthesis too soon, the charge level indicator
via the Cockpit app and by turning over the prosthesis may not correspond to the actual
charge level.
• Use the 757L16* power supply and 4E50* battery charger to charge the battery.
• The battery may discharge while the product is not being used.

6.1 Connecting the power supply and battery charger

1
1) Slide the country-specific plug adapter onto the power supply until it locks into place (see
fig. 1).
2) Connect the round, four-pin plug of the charging cable to the OUT receptacle on the battery
charger so that the plug locks into place (see fig. 2).
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the cable plug to the battery charger.
3) Connect the round, three-pin plug of the power supply to the 12 V receptacle on the battery
charger so that the plug locks into place (see fig. 2).
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the cable plug to the battery charger.
4) Plug the power supply unit into the wall socket.
60
2 3