Switching Mymodes Using Motion Patterns - Ottobock C-Leg 3C98-3 Gebrauchsanweisung

Product
1. Basic Mode 2. Golf
1
2
3
100% 1. Basic Mode

9.2 Switching MyModes using motion patterns

INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see
Page 69).
Information on switching
• Switching and the number of motion patterns must be activated by the prosthetist in the
adjustment software.
• Before the first step, always check whether the selected mode corresponds to the required
motion type.
Switching process
à MyMode 1
3x
4x à MyMode 2
1s
ð
1) Position the prosthetic leg back slightly.
2) While maintaining constant contact with the floor, bounce on the forefoot a number of times in
one second depending on the desired MyMode (MyMode 1 = 3 times, MyMode 2 = 4 times).
3) Keep the prosthetic leg still in this position (lunge position) for about 1 second without lifting
the leg. Taking the weight off is no longer necessary.
→ A beep and vibration signal will occur to confirm that the movement pattern has been
recognised.
INFORMATION: If this beep and vibration signal is not emitted, the requirements
were not met while bouncing.
4) Following the beep and vibration signal, move the prosthetic leg next to the contralateral leg,
set it down and keep still for about 1 second.
1) Tap the symbol of the MyMode (1) you want in the main
menu of the app.
→ A security question for changing the MyMode appears.
change
2) If you want to change the mode, tap the "OK" button.
→ A beep signal sounds to confirm the switch.
3) After switching, a symbol (2) is displayed to identify the act­
ive mode.
→ The current mode is also indicated by the name on the
1x
ð
+
lower edge of the screen (3).
1x 1s
ð
ð
2x à MyMode 1
3x à MyMode 2
ð
MyMode 1
+
MyMode 2
þ
73