End Of Programme - Zodiac VORTEX 3 Montage- Und Gebrauchsanleitung

2-Notice CO ANG.qxd 13/09/10
Diagram 8
Upon starting-up the next time, the operating mode and set time will be those that were ope-
rational when the robot was last used.
•
To stop the cleaner during a programme press on
Remarks:
If you press the key for the current programme it will have no effect.
At the end of the programme the cleaner stops but remains in standby. Press
the cleaner power supply.
Due to the vast range in the shape and size of pool steps, it is possible, the cleaner will
have difficulties in cleaning these areas of a pool.
When the cleaner descends down the pool side, it is normal that it does not remain on the pool wall.
The cleaner lowers its suction power when reversing. Some debris may not be suctioned
during this reverse action.
If the cleaner sucks in air at the water line a safety mechanism is actioned, and it will sink
back to the bottom after a few moments.
The cleaner tends to tip over and float for a few seconds, this is not a malfunction, it returns
to its normal position.
If your pool has an alarm it is strongly recommended that the pool is well filled so that the
robot does not touch the alarm repeatedly and damage it.
It is also strongly recommended to keep the pool shutter open when using the cleaner in "bottom
and sides" mode. In "bottom only" mode there is no risk of damaging the shutter.

3.5.3. End of programme

VORTEX
•
The robot stops and the indicator corresponding to the program is lit. At the end of the
cycle the robot must cool down for 15 minutes in order to avoid potential damage to the
joints. After 15 minutes the indicator will blink meaning that the cleaner can be removed
from the water.
•
Press on the power button
VORTEX
•
The robot stops and the 4 led indicators blink successively in a loop.
Wait 15 minutes before removing the robot from the pool. This corresponds
to the cooling time required in order to avoid potential damage to the
seals.
•
Press on the power button
IMPORTANT: Wait approximately 15 minutes after the end of the programme before
removing the cleaner from the water.
If you wish to run a new programme once the cleaner has stopped press the corresponding button.
9:12 Page 18
TM
VORTEX 4 ONLY:
•
Depending on the condition of the pool you may wish to modify the length
of the cleaning cycle by pressing
one hour or reduce it by 30 minutes by pressing the key a second time.
Pressing a third time will reset to the initial predefined cleaning
times (1 hr 30 or 2 hrs 30).
l'eau.
TM 3
. Diagram
TM 4
. Diagram
. You can increase this time by
Diagram 8.
.
9.
9.
18
to shut off
Diagram 9