Replacing Wheels; Interventions On The Machine - EMAK 93 Gebrauchsanweisung

voltage. Other recharging systems can irreversibly damage
the battery.
The machine comes with a connector (1) for recharging; this is
connected to the corresponding connector for the special
"CB01" maintenance battery-charger supplied (if included) or
available on request ( 9.5).
IMPORTANT
This connector must only be used for
connection to the "CB01" maintenance battery-charger. For its
use:
– follow the instructions in the relevant user manual,
– follow the instructions in the battery manual.

6.3 INTERVENTIONS ON THE MACHINE

6.3.1 Cutting deck alignment
The cutting deck should be properly set to obtain a good cut.
If the cut is uneven, check the tyre pressure.
If this is not sufficient to achieve an even cut, please contact
your Dealer for the adjustment of the alignment of the cutting
deck.

6.3.2 Replacing wheels

Stop the machine on flat
ground and put a block under a
load-bearing part of the frame
on the side that the wheel is to
be changed.
The wheels are held by a snap
ring (1) which can be eased off
with a screwdriver.
NOTE
If you have to replace one or both rear
wheels, make sure that any differences in their external diam-
eter does not exceed 8-10 mm; on the contrary, to prevent an
uneven cut it will be necessary to adjust the alignment of the
cutting deck.
IMPORTANT
Before remounting the wheel, apply
grease to the axle. Put the snap ring (1) and supporting wash-
er (2) back in place.
6.3.3 Replacing and repairing the tyres
The tyres are "Tubeless" and so all punctures must be repaired
by a tyre repairer following the procedures required for this kind
of tyre.
2 1
EN 29