Replacing Belts; Replacing Wheels - EMAK Cheyenne 92-110-132 Betriebshandbuch

6.3.13 Replacing belts

Replacing drive belts is a relatively demanding operation, which needs to performed by an authorised
service centre.
When attaching a new belt pay special attention when working with the machine because
the belt is not yet sufficiently run-in.
Type of belts used:
Mowing deck blade
Machine drive belt – from elmag.
92 4x4x 5L690 Roflex Garden
110 4x4 5L650 Roflex Garden
132 4x4 5L690 Roflex Garden

6.3.14 Replacing wheels

Before replacing one of the wheels, park the tractor on a horizontal and rigid surface, turn off the
engine and remove the key from the ignition. Secure the machine against movement. Do not replace
the wheel if the machine is not sufficiently secured in the elevated position!
If you do not have suitable tools or the necessary knowledge, contact your seller.
Perform the replacement as follows:
} Place the jack underneath the front or rear bumper near to the wheel which
you wish to replace. Always place the jack against the frame, do not lean it
on the transmission - risk of damaging it!
} Keep lifting the machine until the wheel, which you wish to change no
longer touches the ground.
} Remove the protective cover from the wheel.
} Using a suitable screwdriver remove the retaining ring and remove the
washer.
} Pull the wheel off the shaft.
When reattaching the wheel proceed in the reverse sequence to its removal. Before attaching the
wheel clean all parts and lightly grease the shaft with a plastic lubricant. Especially for wheels on the
rear axle this lubrication is essential for the subsequent removal of the wheel. In the event
that lubrication is not performed the subsequent attachment may be very difficult.
When attaching the rear wheel pay attention to the mutual alignment of the pin on the shaft and the
groove on the wheel.
Finally check the tyre pressure.
6.3.15 Repairing a tyre puncture
The machine is equipped with tubeless tyres. In the event of a puncture have it repaired at a specialised
tyre repair shop or at an authorised machine service centre.
transmission
Mowing deck blade
drive belt – from main
belt pulley
(none)
Continental 312 AA126
Right 13 x 1325Li A52
Left AA78 HAA-2032
97
Travel drive belt
X13x830 OPTIBELT