Disposal Of The Packaging - EMAK Cheyenne 92-110-132 Betriebshandbuch

3.2 Disposal of the packaging

After unpacking the machine, ensure that the packaging material is properly
disposed of or recycled. The disposal must conform to relevant waste disposal
laws valid in the user's country.
Disposal may be performed by a specialised company.
3.3 Assembly of the separately packed assemblies
Due to the technical nature of this task the machine is prepared for operation by the
seller of your riding mower (according to the following instructions).
Before starting installation, remove all covering, protective and fastening materials.
a) Install the steering wheel:
} Using a hammer and a suitable rod, knock out the pin (2), which is inserted in the
rod hole (1).
} The steering wheel is set it two height positions, which are set by two holes in the
steering wheel rod. Select the optimal steering wheel position, attach it on to the rod
(1) and turn it so that the holes in the steering wheel and the rod align.
} Reinsert the pin into the hole and knock it in using a hammer.
b) Set the appropriate tilt angle of the steering wheel:
} Set the appropriate tilt angle of the steering wheel by holding back the lever (3).
c) Screw the folding frame into the correct position on the machine:
} Screw out the screws for the attachment of the frame that are screwed into the
washer on both sides of the mower body.
} Seat the frame on the washers. Make sure that the frame is facing in the correct
direction – must tilt towards the rear side of the machine.
} Screw the frame to the washers and fully tighten the screws.
d) Connect the battery:
} Open the storage area under the steering wheel and loosen the bolts on the battery
pole terminals.
} Black wire Place on the (+) pole of the battery and secure in place with the bolt and
nut.
} Brown wire Place on the (-) pole of the battery and secure in place with the bolt and
nut.
Connecting the wires in opposite to that described above will damage the machine.
When disconnecting the battery, always disconnect the negative (–) pole of the battery
first.
When putting the battery into operation and when performing maintenance on it, proceed
according to the instructions in the user's manual for the battery.
Also follow all safety instructions contained therein.
e) Screw the front bumper bar into the correct position on the machine:
} Slide the front bumper bar forwards from the frame of the machine so that the holes
in the frame are in alignment with the holes in the bumper bar.
} Screw the bumper bar in on both sides of the frame using two bolts and nuts. The
bolts and nuts are found in the plastic bag containing the machine's documentation.
Now prepare the machine for the first start up according to the following chapter.
72
3.3a
3.3b
3.3c
3.3d
3.3e