Grass Cutting; Emptying The Grass-Catcher - EMAK 93 Gebrauchsanweisung

5.4.5 Grass cutting

1
A = 10 mm
A = 30 mm
Model 101
Adjust the position of the anti-
chipping wheels (1) whose
function is to reduce the risk
of tearing up sections of lawn,
which can occur when the
edge of the cutting deck
drags over irregular ground.
The four different heights of the wheels allows you to main-
tain a safe distance «A» between the cutting deck edge and
the ground.
To change the position, unscrew and remove the pin (1) then
reposition the wheel (2) in the upper and lower hole of the
wale corresponding to the wheel diameter.
WARNING!
This should always be performed
on both wheels, positioning them at the same height
WITH THE ENGINE OFF AND BLADES DISENGAGED.
To start cutting:
– move the throttle to «FAST»;
A = 0 mm
– raise the cutting deck as high as possible;
A = 20 mm
– only use the blade (
A
– start moving forwards on the grass very slowly and with
– regulate the cutting height and speed (
2
1
Whatever the conditions, always reduce the speed if you notice
a drop in engine speed – if you travel too fast compared to the
amount of grass being cut, you will not be able to mow the grass
well.
Disengage the blades and raise the cutting deck as high as pos-
sible whenever you need to get past an obstacle.

5.4.6 Emptying the grass-catcher

Do not let the grass-catcher become too full as this may block
the collector channel.
4.7), on grass lawns, do not use the
blades on stony ground or when the grass is very high.
utmost caution, as already described;
the conditions of the lawn (the height, density and dampness
of the grass).
WARNING!
When cutting on sloping ground, re -
duce your speed to ensure safe conditions (
NOTE
This operation can only be done with the
blades disengaged, otherwise the engine stops.
4.8) considering
1.2 - 5.5).
EN 21