Checking The Flames; Using The Timer And Thermometer; Icons And Control Buttons; Setting The Timer Alarm - Barbecook QUISSON 4000 Bedienungsanleitung

9.7 Checking the flames

Each time you light a burner, you have to check its flames. A
perfect flame is almost completely blue, with some yellow at the
top. Sporadic yellow flames are normal and not harmful.
If there is something wrong with the flames, do one of the
following to solve the problem:
If the flames are...
1
Low and entirely yellow
2
1
Higher than the bowl
2
3
4
LOW
10 USING THE TIMER AND
THERMOMETER
The appliance is equipped with a timer and thermometer. You
can use them to set an alarm, which can either go off after a
certain amount of time or when the food reached a certain
temperature. You can also use the thermometer to check and
follow up the temperature of your food.
2
If you do not use the thermometer, we recommend
storing the thermometer probe and cable indoors.

10.1 Icons and control buttons

On the timer and thermometer, you find the following icons and
control buttons:
Do the following...
Immediately close the gas supply and
set all control knobs to OFF.
Refer to "15 Troubleshooting" to
determine the cause of the problem.
Most likely, the venturis are blocked.
Immediately close the gas supply and
set all control knobs to OFF.
Wait 5 minutes to allow any
accumulated gas to escape.
Relight the burner(s).
If the problem persists, refer to
"15 Troubleshooting" to determine
the cause of the problem.
HIGH
www.barbecook.com
Icon/button
Clock icon (A) Displayed when you are setting the timer
alarm and when the timer alarm is set.
Probe icon (B) Displayed when you are setting the
thermometer alarm and when the
thermometer alarm is set.
ON/OFF button Allows you to switch the timer/thermometer
on and off and to switch between °C and °F.
SET button Allows you to enter the setting mode, in
which you can set the timer and/or
thermometer alarm.
+ and - buttons Allow you to set the timer or thermometer
alarm to the correct time or temperature.

10.2 Setting the timer alarm

1 Switch on the timer and thermometer by pressing the
ON/OFF button.
2 Press the SET button once or twice, until the display shows
the clock icon and the default setting 0:00.
3 Use the + and - buttons to set the correct time.
4 When finished, do not press any buttons for five seconds.
The timer automatically quits the setting mode. The alarm will
go off after the set amount of time.

10.3 Setting the thermometer alarm

1 Switch on the timer and thermometer by pressing the
ON/OFF button.
2 Plug the thermometer probe into the food.
After a few moments, the thermometer shows the current
temperature of the food.
3 Press the SET button once or twice, until the display shows
the probe icon and the default setting ---.
4 Switch between degrees Fahrenheit (°F) and Celsius (°C) by
pressing the ON/OFF button.
5 Use the + and - buttons to set the correct temperature.
6 When finished, do not press any buttons for five seconds.
The thermometer automatically quits the setting mode. The
alarm will go off when the food reached the set temperature.

10.4 Clearing an alarm

1 Press the SET button once or twice, until the display shows
the alarm that you want to clear.
2 To clear the alarm, press the SET button again and hold it for
a few moments.

10.5 Checking the food temperature

1 Switch on the thermometer by pressing the ON/OFF button.
2 Plug the thermometer probe into your food.
After a few moments, the thermometer shows the current
temperature of the food.
3 If you want to follow up the temperature of your food, leave
the probe plugged in.
4 When finished, remove the probe from the food and switch
off the thermometer by pressing the ON/OFF button.
Description
13