Operation
Fitting/changing the saw blade
Always remove the battery pack before changing
the saw blade
!
1 . Set the cutting depth (using the locking screw
to the minimum position, 0 mm .
2 . Press the spindle lock button
es) and hold it in .
3 . Undo the tensioning screw
4 . Now, remove the tensioning screw
clamping flange
Fig. A: Changing the saw blade
5 . Pull the blade guard
the release lever
in this position .
6 . Remove the saw blade
appliance from below .
7 . Fitting a saw blade
order .
8 . Press the spindle lock button
and use the hex key
screw
.
WARNING!
►
The arrow on the saw blade
spond to the arrow showing the direction of
rotation
(running direction shown on the
blade guard
) .
■
Ensure that the saw blade
rotational speed of the tool .
PHKSA 12 A2
(until it engag-
using a hex key
and the
(see also fig . A) .
all the way back using
and keep the blade guard
carefully out of the
is done in the reverse
(until it engages)
to tighten the clamping
must corre-
is suitable for the
Rip fence
♦
Undo the wing screw for the rip fence
place the rip fence
♦
Set the desired cut width
using the scale on the rip fence
)
out in the base plate
The right recess in the base plate is for a cutting
angle of 0° .
.
Fig. B: Cutting width 2 cm
♦
Retighten the wing screw for the rip fence
Connecting a dust extraction unit
♦
Attach the adapter for dust extraction
chip ejector
Optional depending on the diameter of the dust
and sawdust extraction .
♦
Connect an approved dust and chip extraction
device .
NOTE
►
When sawing wood or other materials that
create dusts that are hazardous to health,
always connect the appliance to a suitable,
certified suction appliance .
Use
Switching on and off
Switching on:
♦
Push the safety lock-out
and keep it pressed .
♦
Press the ON/OFF switch
light
lights up . Once the saw is running, you
can release the safety lock-out
Switching off:
♦
Release the ON/OFF switch
in the rip fence slot
and the cut
(see also fig . B) .
.
to the left or right
. The LED work
.
.
GB │ IE │ NI
and
.
.
to the
│
9
■