WARNING! Protect yourself from laser
radiation!
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
P max.: < 1 mW
λ: 650 nm
EN 60825-1: 2007
This appliance contains a Class 2 laser.
►
NEVER direct the laser beam at people or
animals.
►
NEVER look directly into the laser beam.
The laser beam can cause serious eye dam-
age.
►
Do NOT direct the laser beam at strongly
refl ective material. Refl ected laser beams are
also dangerous.
►
Any adjustment intended to increase the
intensity of the laser beam is forbidden.
There is a risk of personal injury!
►
No liability will be accepted for damage
resulting from manipulation of the laser
equipment or from disregarding these safety
instructions.
Changing the batteries:
■
Open the cover of the battery compartment
with a suitable Philips screwdriver.
■
Remove the spent batteries.
■
Insert two new 1.5 V alkaline button cells (type
AG 13/LR 44, e.g. GPA 76) observing the
correct polarity and screw the battery compart-
ment cover
fi rmly closed.
PHKS 1350 A1
All manuals and user guides at all-guides.com
CAUTION!
If operating and adjustment equipment is used or
procedures other than those specifi ed here are
carried out, this may result in hazardous radiation
exposure.
Original accessories/additional
equipment
■
Only use the accessories and additional equip-
ment that are specifi ed in the operating instruc-
tions and are compatible with the appliance.
Initial operation
Fitting/changing the saw blade
Always pull out the plug from the mains before
changing the saw blade
1. Set the cutting depth (using the locking screw
to the minimum position, 0 mm.
2. Swing the blade guard
lever
and put the device down.
3. Press the spindle lock button
and use the Allen key
screw/washer
. Now remover the clamping
screw/washer
and the clamping fl ange
(see also Fig. A).
Fig. A: Changing the saw blade
4. Remove
saw blade.
5. Fitting a saw blade
reverse order.
6. Press the spindle lock button
and use the Allen key
screw/washer
.
!
back using the release
(until it engages)
to release the clamping
is carried out in the
(until it engages)
to tighten the clamping
GB
)
7