Original Accessories/Auxiliary Equipment; Before Use; Charging The Battery (See Fig. C) - Parkside PHKSA 20-Li A2 Originalbetriebsanleitung

Original accessories/auxiliary
equipment
■
Only use the accessories and additional
equipment which are specified in the oper-
ating instructions and are compatible with the
appliance.
WARNING!
► Do not use any accessories not recom-
mended by PARKSIDE. This can lead to
electric shock and fire.
WARNING! Protect yourself from
laser radiation!
P max. < 1 mW · λ 650 nm · EN 60825-1:2014
Never look directly into the laser beam or the
opening from which it emerges.
WARNING!
► Looking at a laser beam through optical
instruments (e.g. magnifying glasses etc.)
can cause eye injuries.
► Caution! If operating and adjustment equip-
ment or procedures other than those specified
here are used, this may result in hazardous
radiation exposure.
■ Never aim the laser beam at reflective surfaces,
people or animals. Even brief visual contact
with a laser beam can result in eye injuries.
CAUTION!
► If operating and adjustment equipment is
used or procedures other than those specified
here are carried out, this may result in
hazardous radiation exposure.
PHKSA 20-Li A2

Before use

Charging the battery (see fig. C)
CAUTION!
► Always unplug the appliance before you
remove the battery pack
the battery pack to the charger
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C.
♦ Connect the battery pack
charger (see fig. C).
♦ Insert the power plug into the socket. The red
control LED lights up.
♦ The green control LED
charging process is complete and the battery
pack is ready.
CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged.
♦ If the red and green control LEDs
flash, this means that the battery pack
broken.
■ Never recharge a battery pack again immedi-
ately after rapid charging. There is a risk that
the battery pack will overheat and this will
reduce the lifespan of the battery.
♦ Switch off the charger
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
from or connect
.
to the battery
indicates that the
flashes, this means
has overheated and
both
is
for at least 15 minutes
GB │ IE │ NI │
9 ■