Preparing For Use; Tips For Use; Mounting Option For Transformer - Auping Match 355 Gebrauchsanweisung

'Click' the anchors into the mesh at the
positions indicated (see fig. 6).
Make sure that the anchors are not directly
above a cross bar.

3.5 Preparing for use

Check that the mesh base can move freely.
Only adjust the mesh base while it is in a hori-
zontal position, securely fixed to the support-
ing legs, or to the supports provided within the
bed surround.
Check that the mattress is attached to the
mesh base properly.
Insert the plug into the wall socket.
The plug has a safety cut-out.

3.6 Tips for use

A new mattress has a certain amount of rigid-
ity, which will disappear within a few days.
Consequently, your mat tress will not optimally
follow the contours of the mesh base when it
is initially adjusted. We therefore recommend
that you lie down on the mattress while adjust-
ing the positions for the first time.
GB6
_02QY6_3814 BinnenW.pdf - pag.16

3.7 Mounting option for transformer

fig. 6
A mounting plate is clicked to the back of the
transformer. If you wish, this can be used to fix
the transformer, for instance to the wall.
1. Slide the mounting plate A off the trans-
former.
2. Screw the plate to the wall with the spring-
mounted clip B pointing downwards.
3. Slide the transformer, with the mains con-
nection on the left, over the mounting plate.
Important! Be sure to remove the transformer
from the mounting plate before moving the
bed.
LET OP !!! Lage resolutie!
fig. 7
October 6, 2008