Preparing For Use; Components Of Your Mesh Base; Position Of The Legs; Setting The Comfortslides - Auping AVS 466 Gebrauchsanweisung

3. Preparing for use

3.1 Components of your mesh base

Your supplier will install your AVS mesh
base for you. The drive motors should
be fitted by Auping specialists only.
For other parts and detailed installa tion
instructions, we refer you to the
installation cards included with the
various parts.

3.2 Position of the legs*

It is vitally important that the feet be
fitted properly,
appropriate distribution of weight. This
means that the legs must be placed at
the distances from head and foot end of
the bed as indicated in the following
illustration (bed seen from above):
Length 190/200 cm:
Length 210/220 cm:
* If applicable.
to ensure the
Head (H)
Foot (F)
H 20 cm F 20 cm
H 30 cm F 30 cm

3.3 Setting the Comfortslides

The mesh base can be adapted to the
shape of your body. The slides are
incorporated in the mesh base at both
shoulder and hip level.
• Remove the mattress from the mesh
base.
• The illustrations of the various
positions of the Comfortslides
examples only. You can of course set
the slides to the position you
consider the most comfortable.
• Lift the slides slightly, then slide
them to the desired positions.
• Replace the mattress on the mesh
base.
For technical reasons AVS mesh bases
wider than 120 cm cannot be equipped
with Comfortslides
®
® are
® .
GB21