Vacuuming With A Cartridge Filter; Cartridge Filter Self-Cleaning - Parkside PNTS 1400 G3 Originalbetriebsanleitung

GB IE NI
Push the switching lever (21) forward
by foot, the floor nozzle brush (19)
and the floor nozzle squeegee (22)
will extend to make perfect cleaning.
•
For vacuuming dry dirt off the
carpeted floor
Push the switching lever (21)
backward by foot, the floor nozzle
brush (19) and the floor nozzle
squeegee (22) will retract to make
deep vacuuming.
2. Use crevice nozzle (28) to clean edges,
joints, heaters and hard to reach
locations.
3. Hold the air regulation handle (26)
and push the nozzle back and forth to
vacuum / clean.
4. Push the Air regulation cover (27) back
(minimum force) and forth (maximum
force) to get the right suction force for
different surface.
5. Push the telescopic tube button (31) to
extend or retract the telescopic inner
tube (32) to have comfortable working
position.
6. Check the filling volume of stainless steel
container after certain usage, do not
allow the dust wrap the cartridge filter
(36).
7. Add a dry dust bag (33) if necessary.
(See" Cartridge filter / foam filter / dry
dust bag disassembling / assembling" )
The filling level of the dry dust bag
(33) can change on different dust.
Clogged dry dust bag (33) can
burst, replace the dry dust bag (33)
timely.
The dry dust bag (33) needs to
be replaced more frequently while
sucking in fine dust and sand etc.
14
CY
Cartridge filter self-cleaning (Fig. A, J)
The cartridge filter self-cleaning
system is intended for vacuuming up
large volumes of fine dust without
dry dust bag (33).
Only operate the cartridge filter self-
cleaning function without a dry dust
bag (33) inserted, otherwise the
filter bag can get damaged.
Do not operate the cartridge filter
self-cleaning function with wet
cartridge filter.
Do not operate the cartridge filter
self-cleaning function during wet
vacuuming.
1. Connect the suction hose (23) and switch
on the machine.
2. Insert the other end of suction hose (23)
into the accessory mount (16) of the
steering castor kit (15).
3. Push the filter cleaning button (10)
1-2 seconds x 5 while the machine is
switched on, wait 4 seconds between the
individual pushing.
4. Switch off the machine.
After operating the cartridge filter
self-cleaning function several times,
check the stainless steel container
(13) for its filling volume.
Do not allow the dust wrap the
cartridge filter.