Operation; Switching On/Off - Parkside PNTS 1400 G3 Originalbetriebsanleitung

To avoid tearing the foam filter:
- Use only dry foam filter
- Enlarge the foam filter slightly
and then roll it down
3. Dry dust bag
• Always work with the cartridge filter (36)
for dry dust only.
• Remove the motor head (5).
• Unfold the dry dust bag (33) and hold
the dry dust bag collar (34) to pull the
perforation over the internal connection
of suction connector (12)
• Make sure the sealing ring inside the dry
dust bag collar (34) to close the internal
cylinder connection of suction connector
(12) firmly.
• Hold the dry dust bag collar (34) to
remove the dry dust bag (33) when full.
Hose / tube connecting (Fig. A, F)
1. Hold the hose connector (24) and insert
it into the suction connector (12) to an
audible click for connecting, use the
thumb press the hose connection release
button and pull out the hose connector
(24) for disconnecting.
2. Insert the other end of suction hose (23)
into the air regulation handle (26), push
to the end to lock into place.
3. Insert the other end of the air regulation
handle (26) into the telescopic tube (29),
push to the end to lock into place.
4. Insert the other end of the telescopic
inner tube (32) into the switchable floor
nozzle (18), push to the end to lock into
place.
5. Both air regulation handle (26) and
telescopic tube (29) can be removed
from connection depending on the
application.
GB
6. Crevice nozzle can be attached
depending on the application.

Operation

Fully unwind the suction hose (23)
before commencing work.
Switching on/off (Fig.A)
Connect the mains plug.
Do not vacuum without a filter!
How to assemble the filter is
described in the chapter" Cartridge
filter / foam filter / dry dust bag
disassembling / assembling"
Switching On:
On/Off Switch (11) In position "I".
Switching Off:
On/Off Switch (11) In position "0".
Dry vacuuming
Work with a cartridge filter only.
Check the filter for damage prior
to installation and replace as
necessary.
Vacuuming with a cartridge filter
(Fig. A,E, G, H, I)
1. Adjust the switchable floor nozzle (18)
between hard surface floor and carpeted
floor,
•
For vacuuming dry dirt off the hard
surface floor
IE NI CY
13